I’ve tried to report the issue to Prusa support but they keeps trying to diagnose it as user error. But at this point I’m at a loss and presume that it’s either a firmware issue or a sensor issue on my unit.

Either way im very disappointed.

And before you ask, this is the opposite side

PXL_20240301_160413072

EDIT: I will note that this print sheet is ruined for my use case, since those patterns will be shown on the underside of my prints. But the print surface still works and can be used without issue… if you ignore the gouges that are being detailed into every print.

  • Grass@sh.itjust.worksEnglish
    4·
    10 months ago

    No don’t. My parents house came like that when they bought it when I was like 14. The panels continue to slide and crush the filler into dust and the ends also get mashed and delayered.