'Tis the season and I figure I should finally put up some Christmas lights on the house, but ideally I’d like something I can leave up and change colours for other holidays, shots and giggles, etc. So getting some RGB LED strips sounds reasonable.

The problem, potentially, is that it gets below -30° here pretty much every winter. I know this is problematic for batteries, and sometimes other electronics depending on the build, but for a bunch of LEDs with some sort of ZigBee controller I’m less sure.

So: outdoor RGB LEDs when it’s really freaking cold. Anything I should worry about? Any recommendations?

  • Thorry84@feddit.nl
    link
    fedilink
    English
    arrow-up
    3
    ·
    7 months ago

    Not a chance, power supplies contain capacitors that don’t do well at lower temperatures. Even special kinds don’t survive long at those temperatures. You would need to build an isolated enclosure and include a heater and heat management system. This is usually done with multiple layers, so the inside where the electronics is can be maintained at a constant uniform temperature. Moisture is also an issue, so you’d have to deal with that. All that takes up a lot of power, which will cut into the batteries.

    Batteries are a bad choice for something like that. Led lights are super efficient, but when we’re talking about something like a couple of strings around a house it’s a lot of power. Everyone who has to keep their car (or if you don’t have a huge garage their car battery) inside during winter knows that kind of cold kills batteries. So I would recommend powering it from the grid. Something like an outdoor outlet would do fine.

    Much easier would be to just have everything inside and only have a single cable with 24 - 48 volt (depending on the setup) for power and some (or one) control wires. These kinds of wires aren’t that expensive and easy to run. With good water proof connectors it’s easy to plug in and wire up. They aren’t very thick, so only a small hole is needed. Usually they connect to wire terminals on the inside, so the hole only has to be big enough for the wire.

    I think you can get kits for this kind of thing, which makes it easy to setup and get running. Just a pain in the neck to step on a ladder and securely mount it to the roof.

    • brenticus@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      7 months ago

      Hmm, thats a bit different than what the other guy said but by and large is in line with my original concerns. Definitely wasn’t going to use any batteries in this, I’m very familiar with batteries dying in the cold, I have plenty of outdoor plugs.

      Thanks for the advice, this gives me a pretty good idea of the problems and possible solutions.