SOLUTION: runs contrary to common knowledge, but what ultimately helped was:

• INCREASING print speed. The usual recommendation is the slower the better, but at that point, there’s no pressure control over the filament
• ENABLING retraction. Again, usual rec is to disable it for flexibles but turns out it alleviates too much backpressure which leads to filament buckling in the extruder

Also printing hotter than mfg recommends: I printed at 260 (10C over recommended maximum).

Thanks to u/Over_Pizza_2578 for pointing me to the right - opposite to everything else - direction.

I don’t want to have to enter password when I’m accessing my Proxmox admin when I’m home. That’s it :)

I’m in the same boat. I’d like to have something like this integrated with Home assistant but Grocy is just ludicrously complex. It’s like SAS for your fridge, only more complex. With rude developers who always know better than everyone else.

Right. No biggie. Thanks!

Look here for more boner:

https://tteck.github.io/Proxmox/

Lots of simple scripts to set up new stuff, remove annoyances, easy updates…

I have switched from bare metal running on Rpi4 to proxmox and I’ve been super, super happy with it. Things like snapshots and backups make everything a breeze, and it’s really solid.

VM or container? VM is easier and can be usually configured even via Proxmox GUI (Hardware - Add PCI). Various OSes need various levels of effort. Some Linux distros don’t need any more config, Windows on the other hand required a custom GPU ROM on my system to work.

This can be done even with a single GPU, even the built in iGPU.