Not to mention the nasty, big, pointy teeth!
It will almost take grass from me. It’ll come up and sniff it but doesn’t trust quite that much. Then inevitably a loud truck comes by and scares it off. One of these days maybe I’ll get to give it pets.
That’s how I identified my yard bun. Also a cottontail.
deleted by creator
Sorry, I’m just here to make bad taste jokes and post cat pictures. I don’t know the first thing about parenting.
I hope your kitties are doing well tho.
Check your local safe-haven laws. You can drop off teens in some areas.
The biggest hurdle I’ve ran into is that GPS resolution just isn’t accurate enough. If you want something that can follow a planned route without having to rely on a bunch of obstacle avoidance (which is difficult enough in itself) then you’ll have to set up some sort of local RTK in conjunction with the GPS.
Currently I’m just setting my mower up like a FPV drone that I can drive around remotely from the comfort of air conditioning. Hoping someone comes out with a good automated solution.
deleted by creator
Game and Fish handled Roberts’ case, which reportedly resulted in a $250 fine
Hopefully some of these threats are serious. I can picture some bright red tape wrapped around this MF’s mouth.
Remember kids, revenge is a dish best served cold. Wait until the publicity has died down.
Try what again?
It’s gone from the internet now but on the wayback machine you can see the list of confirmed lizard people from 2021. I just don’t see any correlation to what you’re trying to sell.
https://www.vox.com/2014/11/5/7158371/lizard-people-conspiracy-theory-explainer
Or it could have absolutely nothing to do with Jewish people.
Yeah, I’m not sure. Some of it is questionable. I bought some boots from there a few years ago and now keep it bookmarked to check in on the product descriptions.
Just because they are military issue, doesn’t mean they can’t be snazzy
It may be a trick of the lighting. The picture you added looks much better. But I wouldn’t think you would be able to see that kind of errors just from light.
I’ll dig out some old prints tomorrow and see what they look like under a direct harsh light source. I say old because as soon as I started modding my printer, the quality went to shit. I may be able to print TPU and ABS now, but it definitely doesn’t look as good as before I started messing with it.
That’s pretty rough. A bone stock Ender 3 does better than that.
https://i.imgur.com/AZrO380.jpeg
Pull tabs were mostly phased out when I was a kid but these were still around.
My stubbornness knows no bounds.
Lol “constant firmware updates” as a selling point.