Indeed, the article was written with Backblaze B2 as the S3-compatible storage used.

Do I need to wear some sort of special technical fabric fanny pack? I don’t want to inhibit the progress of the pioneers.

If I may ask as an edc lurker, I love the idea of edc, but how do you carry so many useful gadgets? If I put stuff in my phone pocket then it scratches up my phone. If I put stuff in my key/wallet pocket then it unlocks my car randomly. I would carry my lathe in my pocket if it was feasible.

Some sort of chemical reaction. My best guess would be a drop of CA glue that degraded the material over time.

Having a 3d printer is super convenient for any home or shop repairs I need to make. I have so many curtain spacers and custom hooks all over the place now. The key is to get some hours in Fusion or some other good CAD software so you can whip up custom parts in minutes. You may get it wrong the first few times, but a couple minutes of tweaks and then you have a new part printing while you go back to working on other stuff.

The Swedish Maker just put out a video about how transformative 3d printing has been for his workflow. https://youtu.be/p2bClWmKHRM

Not a lawyer, but there are lots of intricacies to this. You can own a trademark without having it be a registered trademark. Registration is expensive and then you are expected to actively defend use of your trademark. Be prepared to pay lawyers to send cease-and-desist letters to parties using your trademark for financial profit. Not to mention you have to be/become a business engaging in interstate commerce using this trademark.

https://www.uspto.gov/trademarks/basics/what-trademark

https://www.uspto.gov/trademarks/basics/how-much-does-it-cost

dedsec doesn’t appear to be a registered trademark in the US at this time.

https://tmsearch.uspto.gov/search/search-results

edit: added the word registered

We are at, bing! 42% efficiency.

Beyond The Office Door has some good reviews of cable management options on their YouTube channel. Their review of the LTT options was particularly well done.

https://youtu.be/yrrRj-F-vJ0

Do you have an auxiliary power connector hooked up to the HBA? Here is the manual.

Awesome project!

you’ve never had 3am Waffle House chocolate milk?

I buy samples from Atomic Filament when I don’t know which filament would work best for a project. They are 50g spools for under $4 each. It is usually enough filament to print out a filament sample card and a small test piece.

Molex MicroFit 3.0 are my gold standard for general purpose low voltage connectors. I buy from an electronics distributor (Digikey or Mouser) and crimp my own connectors. However, I did find a listing on Amazon for pre-crimped jumper wires and connector housings.

https://a.co/d/hrrtj3f

Use an x-acto knife or a $5 PTFE cutter for best results.

Unless every instance goes down we will just call it a partial outage.

Amazing how that Saturday I set aside to build a Voron2 turned into a weeklong adventure. Then the mods, troubleshooting of mods, ERCF, and building of a Trident consumed so much more time. I guess that is just Voron Life.

I would never use a printer without z-tilt adjust as well. The bed is trammed using motors automatically and then the bed mesh just accounts for surface flatness.

Snapraid to a single drive works well if you are fine with daily snapshots of up to 6 drives.