Not a mistake, I’ve got an ender 3 and a cr10. Both are fine, keep your expectations realistic and calibrate each axis, especially the extruders. Use PLA, consider getting a new build plate if your prints won’t stick. I recommend flashing firmware on the ender 3 unless you know what was loaded onto it last, doesn’t have to be fancy firmware just something you know for sure is configured for your printer. A cr10 should probably get firmware as well but I never loaded new firmware on mine and the controller is older so I’m not sure if it’s a good idea.

Don’t forget the cost of filament, if you print a lot you may spend more on filament in a year that your printer budget.

squints… Big L?

Resentment is usually a feeling which has little to do with ethics.

Actions are more easily analyzed for ethical value.

I guess that you’re considering the action of showing resentment by being absent or cold to them.

From a utilitarian perspective this could serve the purpose of communicating your resentment indirectly which may increase the overall good by preventing this scizsm from infiltrating other parts of your life and others. On the other hand this outcome is not guaranteed.

If you apply value ethics of your actions it really depends on what ideals you hold yourself to.

If you take a completely honest person as your ideal, direct communication is probably more ethical than indirect communication, but indirect communication would still be superior to deceiving them into thinking you agree with them in any way.

Instead, you may idealize an honest pacifist who would value indirect communication higher than direct if direct would also come with conflict.

These are my thoughts, I am by no means an expert in ethics.

Eyyy it’s that post I saw a post about being posted

May run a little JavaScript to see if the extension is there or something? I want to try but I don’t want to install that software to test

Ice creamius

For me the tinkering is part of the fun, so old beat up ender 3s are perfect. If you want something ready to go, even a brand new ender 3 won’t give you that 🤣

Did you pop the corn?

It’s okay to cry, but also keep going until you figure it out, and watch freecad tutorial videos. I think learning how to cad on freecad is a nightmare, but once you know how things are supposed to be built it works well.

Y u no pipe yes into apt 🙃

It’s all about the penguins

This meme brought to you by outdated packages in the official repo

Don’t worry, they’re just roommates

Il a des bras

This is why we can’t have raspberry pi

https://www.fbdfrozen.com/hubfs/24-M4MF-0001_03.pdf

Doesn’t look identical but it’s probably similar.

👀 *could be running a cryptominer

In 2025 we boot a whole Linux system to display a logo.

Does it run Wayland? :P

My only input is gitlab is very complicated, never used the others

Beer nog is where it’s at

Lol too bad they only wrote it in English