Yep, you’ll never get it perfect, but a smaller layer height will make the steps less noticeable. Adaptive layer height in cura if you use that can help, but adds a mortal age to the length of the print.
Yep, you’ll never get it perfect, but a smaller layer height will make the steps less noticeable. Adaptive layer height in cura if you use that can help, but adds a mortal age to the length of the print.
Is this the first print you’ve done with it? Have you done any exposure calibration with this resin?
Ethanol should be fine to use as far as I know. Do the holes go all the way through? If so your screen might have dead spots. You can visually inspect the screen by setting it to do a test exposure without the resin tank on it to check. Also obviously check that your tank doesn’t have any failed print bits stick to the sheet.
That last bit goes for people too, it’s called Leukocoria can be am early sign of all sorts of eye disease. It’s a common way retinoblastoma (a thankfully relatively rare child eye cancer) gets caught - it shows up as a sort of white sheen in one eye in flash photos.
I’ve got this on a sticker on my laptop so you definately can get it from red bubble