When do you do the choosing? Try move that left in the process. Saving storage.
When do you do the choosing? Try move that left in the process. Saving storage.
7.5g is a fairly week cup. An espresso is typically around double that.
Nice resource! Thanks
You Borg the whole disk? Or which paths?
Garage is a self hostable s3 compatible bucket
If you’ve ever been to turkiye it’s more likely balloons.
More sugar in tonic than I’m used to in my coffee I must say.
Coffee tonic water at my local cafe is pretty great on a hot day. Give it a go.
What amp you use? Is it stereo?
Love it!
deleted by creator
Inserting Rust comment here :)
Thanks!
Unfortunately I don’t have it on github or anything yet, since I’m just a week into it.
Started with KDE plasma 5 nixos base to see how it looks. Then swapped to hyprland with a few entries into configuration.nix
Tried looking in your .config
files but couldn’t find that weather app. Do you mind providng the name?
Also the neofetch? You’re using?
Clean! I’m setting up hypr on NixOS rn in a VM to get my settings right before I migrate.
Definitely going to take a deeper look at your dot files.
Coffee oils keep rubber moist 👍
Heating up around here so I’m onto to cold brew. Basically a fine mesh strainer cup in a jar that I let sit overnight. 40 grams lasts 2 days.
Give it a good shake when I make it. Roughly 18 hours steep then it’s good to go the next day, nice and cold out of the fridge.
If I’m fasting I have it with just an ice block, but if I’m not ill have it with oat milk in a tall glass, maybe 80 coffee, 20 oat milk. good shit!
Give to a friend / colleague, then make a pen holders, etc.
Then, up your prep/calibration time to reduce wastage.
Melt it low temp into some sort of bowl mould.
Used Prusa MK3s
Which should be known as a “cracker”, but yeah mainstream media fucked the word “hacker” to mean something it doesn’t.
How’s your filament feed at that height, anything getting kinked or stopped? Does it feed in from a different direction? ie from low Benchtop?
Looks like your extruder can grip but not enough/ well enough for the speed. So either it’s too fast or your feed is too slow. Or the temp is too low.
Have you got constant layer height set or variable? The latter could cause it too.