I think your bed is warping slightly as it heats up, which is normal. Set your bed temp to 105 for half an hour before starting your print and see if it still happens. If you have a V0 or other manually levelled printer, get the bed to 105 before levelling.

What are your bed temps for PLA and ASA? Does it still happen if you preheat the bed? If you rotate the print, does the rough spot follow the rotation?

Other than niche Keysight gear that’s has three layers of nameplates because it’s '90s vintage NOS, LXI and USB-TMC have replaced GPIB.

Like that time Keurig used a very special shade of orange on the lid of their pods as DRM?

Applying power by itself doesn’t keep SSDs from degrading like DRAM though. It’s up to the manufacturer to design scrubbing into the controller to correct errors on infrequently accessed data before it’s too far gone.

“fill angle” under infill settings.

If you’re piping any of those commands to or from awk, you can also go.

Yep. I can get ASA down to 12% with an ambient 50%RH using that method.

There are some models out there for wedges with reverse Bowden fittings so you can keep it cracked open all the time.

USB 5V power can be equally noisy, even from a powered hub, so that argument doesn’t make any sense. PCIe has a high current 12V rail available that has much more margin than USB for filtering with an LDO and run your signal chain well above the noise floor of the components.

Besides, Asus Xonar as in the picture can take 12V from a drive connector to bypass the motherboard PCIe 12V “just in case”.

Try running your dryer with the lid propped open a bit. Most Sunlu dryers don’t have a way to get rid of the humid air pulled out of the filament.

Also Professor Charles Javier

J E N O V O

GLOBAL THERMONUCLEAR WAR

Except for that time it was CPE-1704-TKS

V.35 or IEEE-488

Nah, this is Apple. It’s got to be the most expensive: Lemo medical grade.

N connector to SMA, and hardline to USB-C.

But one of those chonky third party ones with the buttons on the sides, and have a FireWire cable coming out of there too for that 2003 feel

Maybe it’s this classic from The Onion?

Try the steak.