F360 parameter entry was so lacking. And what a strange feature to not fill out since as you say it’s basically just a spreadsheet. Hell, let us import actual spreadsheets so I can have a baseline each time for parameters I’m always inputting such as 3d printer specs (line width etc)
meh, yes and no. typical auto desk shenanigans. free for personal use.
yeah, freeCAD is kinda crappy compared to even F360
There’s a table edit plug in that makes it easy. The gripe I have with it is not being able to right-justify numbers (or maybe I haven’t looked close enough)
Yeah, use the mix. /s but also kinda not since the box mix is dang good
This post is like the equivalent of dudes going "Here, come smell this, it’s disgusting!
Does not crash Connect, fyi
While that’s true, the actual empirical curve does not have to be smooth. Or gaussian.
Bitet instead. Those wipes are okay occasionally or while traveling
You can inject CAN bus commands if you can sniff what they’re sending. No firmware modification necessary. Not saying it’s a good idea to do so, but it is possible to do so.
I assume the coastal regions have significantly cheaper sushi than Dallas and Denver.
The verb tweet was the only thing they had going for them.
FYI, to figure this out you would look at the part that plugs into the wall. there’s a bunch of writing on it. at one point it will say something like " input: 120-240 VAC, output: 15 VDC 0.5 A". that’s true for pretty much all transformer bricks. like if you want to see how much a USB brick will supply it will say on there “5V 2A” or whatever.