MyTurtleSwimsUpsideDown

So it was a pan-Scandinavian race.

Well, they don’t have to be dead.

I like this!

My take is that Frankenstein is a surname, and, as Victor was the monster’s progenitor, they are both Frankenstein. If the context is clear enough for some pedant to “well, actually”, then it is clear enough to understand which Frankenstein is being discussed.

Fair point. I just thought the image of safari standing alone in a corner was a funny one. Since I never hear anyone complain about it, but I don’t see anyone stan it either.

Edit: complaints other than it being the mandated engine for iOS.

WebKit: TheyDontKnow.jpg

Darn, they don’t have a pedestal version :(

Where do I find these

Does the math class cover game theory?

It’s not because they’re LED. It’s because they’re aftermarket: illegally colored, and poorly aimed or not aimed at all.

Hard disagree.

1. Waste packaging is a common problem.
2. Lots of folks have cats
3. You can already buy a commercially made strip and strap cutter. This is just fixed size version that uses a more common blade.

Honestly, my bigger gripe with the video is the little dots of hot glue. That feels like wouldn’t hold up (I’ve had cats disassemble store bought scratchers). I’d brush on flour paste or thinned down school glue for non-toxic full coverage. You could even mix in cat nip to encourage use.

I’m sorry, but corporate prohibited public access to the baja beast after the last incident.

deleted by creator

Hate to break it to you, but all numbers are imaginary.

Something is stopping the extruder from extruding and the “fraying” is just little oozes of filament catching on the layers below.

It could be mechanical, but if it is always at the same exact layer it is may be something to do with the geometry and the slicer.

Make sure you have thin wall detection on, so it will fully print walls that are narrower than the extrusion width.

Turning retractions off might help. I’ve never worked with LW-PLA but it could be that those internal pillars getting farther from the shell are causing a retraction that jams the extruder.

Others mentioned feed, make sure your spool is not catching on the spindle. I had this issue with a roll of TPU that was too wide and it kept getting pinned when I closed the filament door. It would print fine until the tension was too much for the extruder. Then it would look exactly like this.

Is confused

And even with the battery; it’s not about the size, it’s how you use it.

Hey Google. Wher is pen Island?

Bump

Looks like walkaway has given up the pretense of being moderates displeased with the Democratic Party. https://i.imgur.com/qhJSBYn.jpeg