The free data source was cut off, there’s several replacements of varying quality depending on region. The met.no one is good for me.

Kinda true, some places develop on machines that don’t have Internet access, air gap between the sensitive data and an outward facing network

I’m on the prusa mini as my first printer and it’s done spectacularly well, the few times I’ve needed a bigger bed I’ve been able to segment the parts and glue it back together.

One thing you haven’t mentioned is where your printer will be, mine is in my living space, so noise is a big concern. Placing down a foam pad and then a paving stone under the printer stops vibrations from echoing through the table it’s on. But the bambu printers though amazingly featured for the price, are noisy beasts.

There’s a datasheet available for your resin, as there is for any volatile product. Print that for your boss and show him the health risks, mostly cancer that he’s opening himself up to liability for.

Prusa firmware is all still on github. They are using a few more machined or injection moulded parts where it makes sense for stiffness or things like the spool holder. Most of the printer and especially anything that might get revisions later is 3d printed

It does eat the pei sheets a bit, but that’s good to even out tiny marks and dings in the sheet. Like the previous poster said. It’s fine to do once in a while to refresh the surface, spring steel sheets are consumables anyway.

Scrub the bed with dish soap and a non stick scourer, dry it right away. Then print on that. Ipa only removes oils from your fingers, there’s other residue it won’t remove

I want to try ‘yo mother f****er’

You will be the last to be minced in the robot uprising

I’ve got a RLC 520 working beautifully with frigate and the coral module. Use the app to set it up and then block it at the router from outside Internet access if that’s a concern. I think it’s a great camera and would recommend

I started with it on proxmox and ran into the same issues with frigate. Though I also have a separate NAS machine running unraid that happily runs my other containers to play around with. I have enough controlled by HA that it was worth dedicating it to one whole machine to run it in the most supported way by the ha devs.

Yes I did a very similar thing, except I went bare metal on the nuc for simplicity of updates and used the backup to Google drive addon to upload and then restore from

Does it make sense to host your own content instead of upload to someone else’s?