Honestly it looks like the nozzle could be too hot cause I don’t see any consisten lines

I start at 62(and stay there) that’s the magic number i found for my sovol 6 and 6 plus, at lower I would experience warping and bad bed adhesion. And I’ve had the same correlation with mine at home and the 3 I have at work

I usually have to run mine between 62-65, kinda depends how cold my house is but that’s the same bed I have on my sovols, also get a playing card and make sure you can barely feel the nozzle on the surface of the card. That’s how I do mine

What’s the bed temp at? I usually have to run mine around 62C for PLA and turn the cooling fan to 20% or off.

Shhhhh I like my run-on sentences.

That’s the one

Children of emotionally distant parents there’s also Drama free. My therapist recommended both to me

I do it as a side hustle. Not super busy but like friends wanting something and charging a little for it. Or light repair work, replacement brackets or custom stuff for people

I like the sovol sv06 Plus. I have 3

Record that shit, and watch the internet roast him