I just created a new tool for my company, and I opted to leave out jQuery as I wanted to see how it would be without it.

After going through the process I don’t think I’ll use jQuery again unless it is already a dependancy. Vanilla pretty much has everything covered that jQuery made easier, just need to be a bit more verbose in some cases, but I’ve found that typically makes the code easier to read and modify.

No hate if jQuery is your thing though, just if you’re on the fence I’d give vanilla a go and see if it fits your needs!

Damn that’s wild, what type of bed is it?

That’s fair, there is a bit of information overload online when looking into it.

If you want my two cents, find the cheapest print with auto bed levelling (mingda magicians are good and cheap) and just start playing around.You don’t need to know much to start, and you learn what you need to as you encounter problems.

That’s how I got into at least, and now been printing for like 5+ years.

If it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it’ll pull off the glue.

Tried them, thing were better for a short bit but now worse, can I have a refund?